Step 6 – Press firmly once you are satisfied with the positioning and get the adhesive to bond with the door and the panel. Make sure to square the panel with the door so go slow doing this step and be careful.

Press into place starting from the bottom and going up. Step 5 – Place the panel evenly and centered on your fridge door. Step 4 – Evenly space 4 more strips in a row and running in the same direction as the side pieces. Then place 2 the same distance from the edge of the top and bottom edges. Step 3 – As you strip the adhesive of their backing (only do one side at this point), place 6 1/4 of an inch from the edge along the vertical sides. Step 2 – Get 20 1 1/2 by 3-inch adhesive strips and strips off their backing one at a time. Step 1 – Place the panel upside down on a flat surface. This is another easy process to do and should only take a few minutes to get done. How to Place Panels on Your Fridge Without Trim Pieces Then replace the screws and tighten them up. Reverse your actions and make sure the trim piece slides under the top and bottom trims’ lip. Step 4 – After sliding the panel into place, put the trim piece back on. There should be a small channel to place the panel inside.

Or simply slide the new panel into place. Step 3 – Once the trim piece is off and out of your way, slide the panel out, if there is one to remove. Just make sure not to pull or wiggle too hard to avoid breaking the trim. If yours is a bit stubborn, a little wiggle action will help loosen it up. Step 2 – Now grab the trim piece at the top and firmly pull and tilt the trim away from the top of the door and remove it completely as well. If there are screws holding the trim top the handle, remove them completely. Step 1 – Loosen the two screws at the top and the two at the bottom of the trim piece. This will probably be the easiest replacement you can do on a fridge when it comes to panels.

Sub zero wood panel installation